![]() The sensor putty should not be used on surfaces with loose or weak finishes, or they are likely to be damaged when removing the sensor. Do not leave the sensor putty attached to delicate surfaces (such as oil or lacquer finishes) for more than a few hours at a time. NOTE: Sensor putty is only intended to be used as a temporary mounting mechanism. ![]() To preserve the useful life of the sensor putty, clean all dirty surfaces before application. The bottom of the sensor doesn’t have to be completely covered with the putty enough of the surface just needs to be covered to ensure good coupling. Try to keep the putty as thin and flat as possible to ensure that air bubbles aren’t trapped between the putty and the sensing surface. Gently flatten the ball out on the bottom surface of the sensor. To apply the sensor putty, roll it into a ball and place it on the bottom of the sensor head. It can conform to uneven surfaces, providing better coupling between the sensor and the vibrating surface. The putty is good for mounting the sensor on both smooth and rough surfaces. ![]() All of these devices are available from Zeppelin Design Labs in a separate accessory kit. For permanent installation of the sensor we suggest using a mounting strap or thin (non-foam) double sided tape. For temporary mounting we suggest using sensor putty (supplied with the microphone) or a spring clamp. We have found a few very practical mounting methods which cover a wide variety of applications. There are many ways to mount the sensor to a vibrating surface. Nothing affects the bandwidth and frequency response of contact microphones more than how well the sensor is attached to the vibrating surface. With contact microphones the concept of coupling is very important. CAUTION: This tape will likely damage fine oil and lacquer finishes. 2 discs double-stick tape – permanently and securely attach the sensor to any smooth surface.Recommended for musical instruments with fine finishes. 6 pats of sensor putty – temporarily attach the sensor to any surface at all.Custom hold-down strap with screws – permanently attach the mic to any surface that will take a screw especially well-suited to the underside of staging, dance floors, and basketball courts.4″ spring clamp – attach mic temporarily and securely to the edge of any object up to 1″ (2.5 cm) thick.The kit contains a variety of clamps and adhesives to attach the Cortado MkIII contact microphone to virtually any surface. The Cortado MkIII Owners Guide contains application notes and tips for use of each item in the attachment accessory kit. Zeppelin Design Labs Cortado MK III Attachment Accessory Kit Description
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |